Use of appropriate personal protection equipment is required




Download 14.99 Kb.
NameUse of appropriate personal protection equipment is required
A typeDocumentation
MeltonCraft™ Tapered Column Cover Installation Instructions

2) Trim shaft pieces to 2¼" shorter than opening—2" for cap/base, ¼" for expansion (¼" if not using cap and base—each part is 1" thick.) Always trim from bottom ONLY- top is marked.

1) Measure overall opening from floor to beam or soffit (must have structural pressure-treated post or lally column for load support.)

5) Lay 3 panels flat and apply

adhesive to center joints. (Poly-urethane glue is recommended. Follow manufacturer's instructions.)

6) Assemble three panels, using

miter joints.

4) Glue base platform pieces using biscuits (supplied). Center and attach base to floor/pedestal with appropriate fasteners.

7) Finish nail three panels together.

3) Slide ¾ cut base platform

section around post.

8) Slide assembled 3-sided column around support (on top of base platform).

9) Slide ¾ cap platform section into place on top of column

panels.*

18) Clean surface of column with cleaner recommended by the paint manufacturer. Paint with 2 coats of acrylic latex paint.

17) Caulk using latex caulking compound to fill any gaps and nail or screw holes.

16) Center trim moldings around shaft. Apply adhesive to base trim moldings and pin-nail into base platform. (Do not attach to shaft.) There should be about a 1/16” gap around shaft.

15) If base trim moldings are too long, use miter saw to cut base trim pieces to fit around bottom of column.**

14) Use column shaft to check length of base trim molding. If trim is too long, mark cut lines for miters. Moldings should be about 1/8” longer than the width of the column.**

13) Apply glue to final ¼ cap piece and biscuits and slide into place. Pin nail cap moldings to top of

column.*

12) Assemble final panel to column using miter joint. Nail panel to secure in place.

11) Apply adhesive to final panel.

Warning: the precision machined edges of MeltonCraft CPVC column components can be extremely sharp. Use of appropriate personal protection equipment is required: wear gloves when handling the product, wear a dust mask when cutting the product, and always wear eye protection.
Use of polyurethane adhesive, such as Gorilla Glue®, Loctite® PL Premium® Adhesive, Christy’s™ Clear PVC Pipe Cement (or other clear PVC cement), or similar products is recommended. Always observe adhesive manufacturer’s instructions.
Assembly is easiest with pneumatic or electric pin-nailers. These should recess the head of the pin nails far enough that only a minor touch-up is necessary (touch-up with caulk prior to painting.)

10) Raise 3/4 cap platform section to beam/soffit, center, and attach. There should be 1/4" space for expansion between column and cap platform.

Please note the correct assembly of the miter joint shown at the left. Nails MUST be installed only in the edges shown (3 and 4). Installing on the other edges may result in open seams.

1) Glue both joint edges; slide first joint together

2) Push second joint closed

3) Nail this joint first

4) Nail this joint second
Notes:

Panels are marked “TOP” — trim from the bottom only.

Cap and base pieces are also marked as “CAP or “BASE”

Only use non-corrosive fasteners — galvanized, stainless steel, etc.

Always follow glue and paint manufacturer’s instructions.
*Column must not be allowed to collect water, debris, etc. If the top of the column extends beyond the soffit/beam, the cap must be flashed with lead, copper, aluminum, etc. to prevent entry of water or foreign materials.

Melton Classics, Inc. * PO Box 465020 * Lawrenceville GA 30042 * 1-800-963-3060 * www.MeltonClassics.com

Melton Classics, Inc. * PO Box 465020 * Lawrenceville GA 30042 * 1-800-963-3060 * www.MeltonClassics.com

Share in:

Related:

Use of appropriate personal protection equipment is required iconMinimum required personal protective equipment ( see critical actions...

Use of appropriate personal protection equipment is required iconBandsaw do not use this machine unless you have been instructed in...

Use of appropriate personal protection equipment is required iconThe Scope of Work is furnishing all labor, materials, equipment and...

Use of appropriate personal protection equipment is required iconRegulations (e g. Mental Health Act, Public Hospitals Act, Personal...

Use of appropriate personal protection equipment is required iconDear Reader, May I take a few minutes to tell you about personal...

Use of appropriate personal protection equipment is required icon1. System shall be a microprocessor based fully integrated lighting...

Use of appropriate personal protection equipment is required iconThis program contains the rules and rates governing the writing of...

Use of appropriate personal protection equipment is required iconPre-upgrade installation considerations Before upgrading your existing...

Use of appropriate personal protection equipment is required iconRequired unit inventory for home with 4-6 occupants. Homes that sleep...

Use of appropriate personal protection equipment is required iconNote to specifier select one of the following paragraphs as required...

Use of appropriate personal protection equipment is required icon$50. This includes the eggs, the rental fee for use of the equipment...

Use of appropriate personal protection equipment is required iconHydraulic Track Excavator – (these specifications are designed to...

Use of appropriate personal protection equipment is required iconScope this document describes the functional specifications for the...

Use of appropriate personal protection equipment is required iconExperience Equipment General rules on using Equipment Non Player...

Use of appropriate personal protection equipment is required iconManual Review of emergency procedures and equipment: Fire drill procedure,...

Use of appropriate personal protection equipment is required iconLate model digital printing equipment, muller martini perfect binder...

Use of appropriate personal protection equipment is required iconThis master minimum equipment list operational and maintenance procedures...

Use of appropriate personal protection equipment is required iconTrust Protection Platform 17. 2

Use of appropriate personal protection equipment is required iconU. S. Customs and Border Protection

Use of appropriate personal protection equipment is required iconU. S. Customs and Border Protection




manual




When copying material provide a link © 2017
contacts
manual-guide.com
search