Product Specifications F5D9230-4 v3000
Wireless G Plus MIMO Router
F5D9230-4 v.3000 Wireless G Plus MIMO Router Product Specification (Draft)
Belkin Corporation Networking Group 501 West Walnut Street Compton CA, 90220-5221, USA
Table of Contents
Table of Contents 2
1. Introduction 3
2. Product Overview 3
2.1 Features 3
2.2 System Requirements 4
4
2.3 EZ Install Wizard System Requirements (not required to use Router): 4
4
3. Router Hardware Specification 4
3.1 Platform 4
3.2 Standards Supported 4
3.3 Ports / Connectors / Buttons 4
3.4 LED Indicators 4
3.5 System Reset 5
3.6 Mechanical / Power / Environment Conditions 5
4. Wireless Radio Specification 5
4.1 Chipsets 6
4.2 Antennas 6
4.3 Wireless Networking Standards 6
4.4 Frequency Band 6
4.5 Modulation 6
4.6 Data Rates 6
4.7 Power Output 6
4.8 Wireless Channels 6
4.9 Wireless Security 6
4.10 Operating Range 7
5. Router Software Specification 7
5.1 Features (Default Settings) 7
5.2 Protocol Supported 9
5.3 ISP Protocol Supported 9
5.4 VPN Support 9
5.5 Firewall 9
5.6 Port Forwarding 10
5.7 Supported Clients 10
6. Package Contents 10
7. Regulatory Certifications / Compliance 11
8. Intended Markets 11
1. Introduction
This document covers the functional description, specification and deliverables of this project.
2. Product Overview
The Belkin F5D9230-4 Wireless G Plus MIMO Router is a WLAN Router with 4 LAN ports. The Router operates on 2.4GHz frequencies, which conforms to the IEEE 802.11b/g wireless standards. The router features It features MIMO MRC smart antenna technology in 1x2 (TX/RX) configuration to enhance reception, Range-OVERDRIVE technology to increase range, and Packet-OVERDRIVE technology to increase throughput between products based on the same technologies. The Router is to be used with either a Broadband ADSL or Cable Modem via the WAN port to share broadband connections with up to 4 computers via the LAN ports and 14 computers via the WLAN. Each LAN port supports 10/100 Base-T Networks with auto sensing and switching compatibilities. The Router’s EZ install software operates on Microsoft’s Windows 98SE, Me, 2000 and XP and on Mac OS X. The Router can be configured through a web-browser interface. The product is designed for the home and small office and will be available through major retailers and online retailers.
2.1 Features
Enables sharing of broadband Internet connection
Works with both PCs and Mac computers
Connects four computer/devices through the LAN ports
Connects 32 computer/devices wirelessly (TBC)
Operates on 2.4 frequency band including G Plus MIMO mode
Conforms to IEEE 802.11b and 802.11g standards
Security supports WPA/WPA2-PSK/RADIUS & 64/128-bit WEP Encryption
802.11e / WMM Quality of Service (TBC)
Double firewalls: NAT and SPI
Built-in DHCP server
Mac address filtering
VPN pass-through
Web-based advanced user interface
Universal Plug and Play (UPnP)
Parental Control to filter viewable websites
Intel Centrino and Microsoft X-Box Live compatible
Easy Installation wizard
2.2 System Requirements
Broadband Internet connection with RJ45
At least one computer with an installed network interface card
TCP/IP networking protocol installed on each computer
Internet browser
2.3 EZ Install Wizard System Requirements (not required to use Router):
A PC running Windows 98SE, ME, 2000 or XP, or
A Mac computer running Mac OS 9 and OS X
Minimum 64MB RAM
A CD-ROM drive
Internet browser
3. Router Hardware Specification
3.1 Platform
CPU: ADC (chip model number TBC)
Switch: Broadcom BCM5325 (TBC)
Flash: 4MB
Memory: 16MB
mPCI slot: 1 slot for Wireless G Plus MIMO mPCI radio card (TBC)
3.2 Standards Supported
IEEE802.3, IEEE 802.3u 10/100Base-TX, auto negotiation, auto MDIX
3.3 Ports / Connectors / Buttons
WAN port: 1 x RJ11 (for connection to cable or DSL modem)
LAN port: 4 x RJ45 (for connection to local computers / devices)
Power: 1 x DC input jack
Reset: 1 x reset button
3.4 LED Indicators
Power Solid Green – power on
Off – power off
Wireless Solid Green – wireless enabled
Blinking – wireless activity
Off – wireless disabled
Internet Solid Green – connected to the Internet
(Connected) Blinking Green – data being transferred
Off – not connected to the Internet
Modem Solid Green – connected to the modem
(WAN) Blinking Green – data being transferred
Off – not connected to the modem
LAN 1-4 Sold Green – computer 1, 2, 3 or 4 linked to network
Blinking Green - data is transferring on computer 1, 2, 3 or 4
Off – computer 1, 2, 3 or 4 not connected to network
3.5 System Reset
Via recessed reset button
Reboot router: Push and release
Restore default settings: Push and hold 5 seconds
3.6 Mechanical / Power / Environment Conditions
Enclosure: Belkin Medium Router enclosure
Dimensions: mm x mm x mm (L x W x H) (TBC)
Weight: x lbs (TBC.)
External AC/DC power adapter
Type: Linear (plug vary by region)
Input: 100~240VAC 50/60Hz (vary by region)
Output: 12VDC 1A (TBC)
Temperature Range: Operating - 0 ~ 60 C
Storing - 20 ~ 80 C
Humidity: Operating – 10 ~ 85% non-condensing
Storing – 5 ~ 90% non-condensing
4. Wireless Radio Specification
4.1 Chipsets
BB/MAC: Ralink (TBC)
Radio: Ralink (1TX, 2RX) (TBC)
4.2 Antennas
Three dipole antennas with 2 dBi gain
4.3 Wireless Networking Standards
802.11b & 802.11g (WiFi certified)
4.4 Frequency Band
ISM Band, 2400-2483.5MHz
4.5 Modulation
802.11g: OFDM (64QAM, 16QAM, QPSK, BPSK & True MIMO)
802.11b: CCK (11 Mbps, 5.5 Mbps)
DQPSK (2 Mbps) DBPSK (1 Mbps)
4.6 Data Rates
802.11g: 54, 48, 36, 24, 18, 12, 9, 6 Mbps
Auto fallback for extended range
802.11b: 11, 5.5, 2, 1 Mbps
< 1Mbps XR (Auto fallback for extended range)
4.7 Power Output
Low Data Rates: +20 dBm (100mW) (TBC)
High Data Rates: +17 dBm (50mW) (TBC)
4.8 Wireless Channels
North America 1-11
Europe 1-13
Australia 1-11
Most of Asia 1-13
4.9 Wireless Security
WPA2-Enterprise (RADIUS)
WPA2-Personal (PSK, with AES & TKIP)
WPA-Enterprise (RADIUS)
WPA-Personal (PSK, with AES & TKIP)
WEP 64-bit & 128-bit
Disabled
4.10 Operating Range
Indoor: 700ft
Outdoor: 1500ft
Maximum throughput: 45Mpbs or better
* Distance and throughput vary depending on your networking environment.
5. Router Software Specification
5.1 Features (Default Settings)
Operating system: Linux
GPL source code and binary code required for posting
Web-based advanced management configurable from client browsers
Password protected user interface (blank)
Firmware user upgradeable
Progress bar when updating settings
Home - status page – each item with direct link to individual feature page
System date/time
Version info – firmware, runtime code, modem code, HW, serial#
Features status – NAT, firewall, UPnP on/off
Internet info – IP, gateway, DNS servers
LAN settings – MAC, IP, subnet, DHCP server on/off
WLAN settings – on/off, MAC, mode, SSID, channel, security
Help
Login/logout
Show current Internet Status
LAN settings
IP address (192.168.2.1)
Subnet mask (255.255.255.0)
DHCP server (on)
Lease time (Forever)
Local domain name (blank)
DHCP client list (auto refresh)
Internet WAN
Connection type (Dynamic, see more below)
DNS address - primary and secondary (auto from ISP)
point DNS test script to "heartbeat.belkin.com”
MAC address (off)
list router’s MAC address
clone computer’s MAC address
Wireless options
Wireless function (on)
Channel selection (auto)
SSID Broadcast (on)
Encryption - WPA, WPA2, 64/128-bit WEP (Disabled)
Quality of Service (802.11e)
enabled/disabled (enabled)
ACK mode (immediate)
Use as an Access Point (off)
Firewall
Double firewalls: NAT and SPI
Firewall enable/disable (enabled)
Virtual servers (disabled)
preset services of popular applications
allow for configure custom servers
Client IP filters (disabled)
IP range/port range/TCP, UDP or both/block time
allow for enabled/disabled individual filter
Mac address filtering (disabled)
option of white list/black list
allow for enabled/disabled individual filter
URL blocking (disabled)
add URL/keyword
clear one/clear all
DMZ (disabled)
add to list/select from list
DDNS – through DynDNS.org
update Dynamic DNS
enable auto update DDNS (enabled)
WAN ping blocking (enabled)
Security log (enabled)
log traffic and event
save log file (.txt) and clear log
Utilities
Parental Control (ready for sign-up)
subscribe now
interact with Bluecoat/Cerberian server
allow for activated/deactivated
Restart router
Restore default settings
Save current configurations
Restore previous configurations
Firmware update
auto firmware check if enabled in system settings
manual firmware check
browse firmware file (.bin) to update
System settings
login timeout (10 minutes)
primary / secondary time (NTP) servers (TBD)
select time zone (PST)
auto adjust for daylight saving (on)
NAT enabling (enabled)
UPnP enabling (disabled0
auto update firmware enabling (disabled)
Remote management (off)
from any IP or specific IP
select remote management port (8080)
5.2 Protocol Supported
TCP/IP, UDP, CSMA/CD, DHCP, AppleTalk, NetBEUI
5.3 ISP Protocol Supported
Dynamic
Static
PPPoE
PPTP
Telestra Bigpond (Australia)
Multiple PPPoE (Japan)
5.4 VPN Support
PPTP, L2TP, PPTP/L2TP VPN pass-thru
One tunnel to each VPN server
Tunnel disconnect reset: 60 sec
5.5 Firewall
NAT (Network Address Translation)
SPI (Stateful Packet Inspection)
Protection from the following types of attacks
Denial of Service (DoS)
IP Spoofing
Land Attack
Ping of Death
IP with zero length
Smurf Attach
TCP null scan
SYN flood
UDP flooding
Tear Drop Attack
ICMP defect
RIP defect
Fragment flooding
Hacker logging (HTML viewable)
All ports stealth
Must be able to recover from attack without failing
5.6 Port Forwarding
Custom Ports
DMZ (exposed host) (all ports open)
50 Max forwarding entries
Public / Private port translation
Forward Ranges
Can forward UDP and TCP separately or simultaneously
5.7 Supported Clients
The following clients must be tested and verified
Any TCP/IP enabled client running:
Windows 98 / 98SE / Me / NT SP 6.0+
Windows 2000 / XP SP1 & 2 / XP x64
Mac OS 9, 10.1, 10.2, 10.3 and 10.4
Linux
Unix
6. Package Contents
Wireless G Plus MIMO Router
Quick Install Guide
User Manual
Easy Installation Wizard software CD-ROM
Belkin-branded Ethernet Cable
Power Adapter
7. Regulatory Certifications / Compliance
US: FCC B ID (EMC & Wireless) Canada: ICES (EMC & Wireless) Europe: CE, ETS 300 328, ETS 300 836 (Wireless)
EN50081, 50082, 60950, 61000-3-2, 61000-3-3 (EMC) Australia: C-Tick (EMC) Worldwide*: Wi-Fi, Centrino, RoHS, WEEE * The design is required meet and pass additional regional certification for the regions listed below. Certification will be done on as needed basis.
8. Intended Markets
North America: USA, Canada, Mexico Europe: United Kingdom, France, Germany
Spain, Italy, Netherlands Asia / Pacific: Australia, New Zealand
Japan, China, Taiwan, Korea
Singapore
Belkin Corporation Confidential
Networking Group
|